Closed cooling tower is a cyclical equipment, however, in the whole process of the equipment operation is going to be a more operational standards, but closed cooling tower if really want to use, so they can direct and contact with air, but also can carry more by means of evaporation and convection heat to the air cooling unit.

(1) in the closed cooling tower in the process of practical application, will have more and more attention, deceleration machine often check the oil mark position, and recommended lubricating oil must have a variety of hyperbolic gear oil, and other industrial oil, when it's summer in some relatively large viscosity of oil, running for the first time, be sure to look at the operation of the standard, if after more than 20 days, be sure to have all of the oil drain, put on the new oil.

(2) in the closed cooling tower for actual operation at the same time, there is going to be a fan or more before the operation of the reducer, and other standard operation in accordance with the relevant specification for inspection, in particular the motor wiring, wiring in actual choice at the same time, will have a variety of different options, and some aspects are not consistent, particularly likely to cause errors wiring, conform to the requirements and then start, after the order of the boot is different, from the Angle of low speed to high speed blade, can also according to the provisions of the relevant numerical for installation, if must carry on the high speed, It may be more or less above the original rated value.

(3) while the closed cooling tower is actually installed, some stabilization measures of circulating water should also be seen, and even more installation guarantees should be provided.